![\"\"](\"https:\/\/www.bracketracer.com\/wordpress\/wp-content\/uploads\/2020\/04\/DEC15F38-1557-415F-BD77-B945DD488A8C.jpeg\")
<\/a><\/p>\nNext is the cotton batting.\u00a0 I had ordered 5 yards of 2″ loose cotton batting, expecting that I could do both the seat back and bottom with it.\u00a0 After test-fitting the cover a few times, I kept adding more batting, and ended up using all 5 yards.\u00a0 I think it could even use some more.<\/p>\n I got the batting from https:\/\/fabricwarehouse.com\/<\/a> which sells it by the yard.<\/p>\n I put the first layer on and tacked it down with some hog rings.<\/p>\n I cleaned up the original stay wires and put them into the sleeves in the new cover.<\/p>\n Then I put the cover on top edge first:<\/p>\n A few rings to tack it down, then over to tuck the bottom edge in and snug it up<\/p>\n The result with one layer of batting was really too loose<\/p>\n So I added more batting…twice…<\/p>\n I found another trick to snugging the cover on easily.\u00a0 Thread a ziptie through the frame, and through the sleeve with the stay wire, and then zip it up until it is tight.\u00a0 Then it’s easy to add the hog rings.<\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n